S&B Cold Air Intake - 20-22 6.7 Power Stroke
Are you ready to up your airflow for improved performance and fuel economy with the highest quality cold air intake on the market for your 6.7L Power Stroke? If so, you found it!
SB builds cold air intakes, and that's all that they make, so they're pretty darned good at it. With SB, you'll find that they only use the highest quality materials coupled with the best machinery built in the USA and do it all at a price point that's pretty tough to beat.
MAXIMUM PERFORMANCE - This cold air intake for the Ford 6.7L Powerstroke was engineered to minimize air restriction and flow better than stock. This kit comes with a fully enclosed airbox that protects the filter from dirt and keeps out engine heat.
NEW SNAP IN LID DESIGN - S&B's new snap-In lid design requires no screws to secure it to the box. This makes installation and inspection quick and easy, as the filter can be installed and removed without having to remove the intake tube. The silicone edge trim ensures an airtight seal, protecting against unwanted, power-robbing engine heat. This kit comes with a massive, highly-efficient air filter which results in better performance and protects your engine. Available in either 8-layer Cotton Cleanable or Dry Extendable media.
LESS RESTRICTION. MORE AIRFLOW - The Intake Tube has minimal bends as it connects to the turbo inlet. It is positioned in one clean line with minimum obstructions from the turbo inlet to the intake box and air filter. This results in a decrease in restriction compared to stock.
CHOOSE YOUR AIRFLOW - This intake kit has (2) airflow configurations. S&B includes a silicone box plug that can be installed or removed depending on personal preference and airflow requirements. Silicone Box Plug removed: - This configuration will provide an extra air inlet that will be pulled from the passenger side fender area. Silicone Box Plug installed: - This configuration will seal the secondary air inlet located on the side of the box facing the vehicle fender. The front-facing grill inlet and the front scoop will become the main source of airflow into the Intake Box.
NO CHECK ENGINE LIGHTS - S&B devotes a huge amount of resources to engineer our intakes that allow your engine to run properly with stock calibration or enhanced tuning. An injection molded MAF plate in conjunction with a foam MAF sensor gasket ensures a true OE seal to the sensor.